Welcome to Ubucy store

QNAP QXP-W6-AX200 PCIe Wi-Fi 6 Network Card for NAS & PC

Out of stock
€99.99

QNAP QXP-W6-AX200 PCIe Wi-Fi 6 Network Card for NAS & PC

 

The QXP-W6-AX200 is a PCIe Gen 2x1 Wi-Fi 6 wireless adapter with an Intel® Wi-Fi 6 AX200 module that supports the IEEE 802.11ax standard (backwards compatible with 802.11a/b/g/n/ac), MIMO 2Tx2R, MU-MIMO TX/RX and Bluetooth 5.0. The QXP-W6-AX200 can be installed in a QNAP NAS, or Windows®/Linux® PC to provide fast Wi-Fi 6 connection speeds. The QXP-W6-AX200 can also be used with Wi-Fi 6 router to deploy Wi-Fi 6 network environment. A full-height bracket is pre-installed on the QXP-W6-AX200 and two low-profile brackets are also included.

  • The QXP-W6-AX200 supports Wi-Fi 6 802.11ax, provides up to 2400Mbps connection speeds, and is backwards compatible with 802.11acR2/ abgn
  • The QXP-W6-AX200 supports MU-MIMO 2Tx2R, providing greater connectivity with multiple clients; OFDMA increases network efficiency and decreases packet delay
  • The QXP-W6-AX200 has dual band 2.4GHz/ 5GHz antennas, multiple angle tilt, and a magnetic base for the best signal strength direction and location
  • The QXP-W6-AX200 supports BSS coloring that marks shared frequencies with a number for easy differentiation
  • Bluetooth® 5.0 provides faster speeds and wider range to easily connect to multiple devices (Notes: Bluetooth® 5.0 is only available when installed in a Windows® PC and requires an internal USB connection)
  • Wi-Fi 6 uses 1024-QAM to provide a signal packed with more data, and enables 25% faster data rates than 256-QAM
  • Controller IC: Intel AX200 wireless module
  • PCIe interface: PCIe Gen2 x1
  • Theoretical maximum performance: 2.4Gbps (5GHz)
  • Antenna: 2T x 2R
  • Antenna height: 17 cm (includes magnetic base)
  • Antenna extension cable length: 80 cm
  • Supported operating systems: QTS 4.4.3 or later; 64-bit Windows 10® PC (download and install driver from Intel website); Linux kernel 5.1 or later (download and install driver from Intel website)
  • Hardware requirement: NAS or PC with a PCIe slot, 64-bit processor and operating system.
  • Package contents: 1 x QXP-W6-AX200 card (GC-WBAX200 QNAP edition, a full-height bracket is pre-installed); 1 x installation guide; 2 x half-height low-profile brackets (a standard bracket and a flat bracket for NAS); Windows 10® driver CD.
  • NAS Software Spec: Supports QTS 4.4.3 or later
  • Security Protocol: No Auth / WEP / WPA-Personal / WPA2-Personal
  • Supports the Captive Portal authentication method: Access WiFi via the configuration by Qfinder utility / Browser Station

Add a review

Be the first one to review this product.

Your review is submitted for approval