Anycubic
Anycubic SP ACE Pro Filament Detector for ACE Pro/Kobra 3 Combo/V2 Combo/Max Combo/S1 Combo
Κωδικός παραγγελίας: 30786
- Compatible Models:Anycubic ACE Pro / Kobra 3 Combo / V2 Combo / Max Combo / S1 Combo
- Sensor Type:Photoelectric / Optical IR Filament Presence & Motion Sensor
- Operating Voltage:3.3V / 5V DC (supplied via ACE Pro mainboard)
- Supported Filament Diameter:1.75 mm
- Materials:FR-4 PCB, high-temperature ABS/PC molded guide housing.
- Όλα τα χαρακτηριστικά
12,99 €με ΦΠΑ
Αποστολή σε 2-4 εργάσιμες
Δωρεάν παραλαβή από το κατάστημα
Περιγραφή
- The Anycubic SP ACE Pro Filament Detector: is a specialized sensor board module engineered for the Anycubic Color Engine (ACE Pro) system used across the Kobra 3 Combo, V2 Combo, Max Combo, and S1 Combo lineups.This module actively monitors filament presence, motion, and feeding status within the multi-color feeder paths, enabling automatic spool switching, runout detection, and prevention of multi-color retract jams.
- Real-Time Filament Runout Sensing: Features high-precision optical/photoelectric sensors that immediately signal the printer firmware when a spool depletes, pausing the print safely.
- Clog & Tangle Detection: Monitors filament feed motion through the ACE Pro internal channels to detect feeding resistance, tangled spools, or feed slip before motor grinding occurs.
- Multi-Channel Compatibility: Designed to drop directly into the feeder channels of the ACE Pro multi-material unit for seamless multi-color filament swapping.
- Direct Plug-and-Play Integration: Pre-fitted with quick-connect JST wiring headers, requiring no soldering or wire stripping during maintenance or replacement.
Χαρακτηριστικά
- Compatible Models
- Anycubic ACE Pro / Kobra 3 Combo / V2 Combo / Max Combo / S1 Combo
- Sensor Type
- Photoelectric / Optical IR Filament Presence & Motion Sensor
- Operating Voltage
- 3.3V / 5V DC (supplied via ACE Pro mainboard)
- Supported Filament Diameter
- 1.75 mm
- Materials
- FR-4 PCB, high-temperature ABS/PC molded guide housing.
- Keep Optical Paths Clean
- Dust off any filament debris, plastic shavings, or stringing inside the sensor feed tube during installation using compressed air, as debris can block the optical light bridge.
- Verify Connector Latch
- Ensure the small multi-pin connector snaps fully onto the main hub board to avoid false "Filament Missing" or "Feed Error" pop-ups during multi-material prints.
- Calibrate ACE Pro After Swap
- Run a self-test cycle from the printer screen after replacing S010301 to ensure all 4 loading channels load and retract smoothly.
- Item Weight
- ~ 8 g to 15 g (sensor PCB with housing/wiring)
- Sensor Board Dimensions
- ~ 25 x 18 x12 mm
- Lead Harness Length
- ~ 60 mm - 90 mm
